Справочник Пользователя для Siemens MC35
AT Command Set
MC35_ATC_01_V05.00
Page 62 of 256
15.07.2002
3.27 AT+FVRFC Vertical resolution format conversion
Test command
AT+FVRFC =?
This command determines the DCE response to a mismatch between the vertical
resolution negotiated for the facsimile session and the Phase C data desired by
the DTE.
resolution negotiated for the facsimile session and the Phase C data desired by
the DTE.
Response
(List of supported mismatch checking modes) OK
Parameter
See write command
Read command
AT+FVRFC?
Response
<vrfc> OK
Parameter
See write command
Write command
AT+FVRFC
=<vrfc>
=<vrfc>
Response
OK
Parameter
<vrfc>
0
disable mismatch checking.
2
enable mismatch checking, with resolution conversion of 1-D
data in the DCE, and an implied AT+FK command executed
on 2-D mismatch detection
data in the DCE, and an implied AT+FK command executed
on 2-D mismatch detection
Reference
EIA PN-2388
Note
Used for Fax class 2 only
The following AT commands are dummy commands. Invoking these commands will not cause ER-
ROR result codes, but these commands have no functionality.
AT+FAA
ROR result codes, but these commands have no functionality.
AT+FAA
Auto Answer mode
AT+FECM
Error Correction Mode control
AT+FLNFC
Page Length format conversion
AT+FLPL
Indicate document available for polling
AT+FMINSP
Minimum Phase C speed
AT+FRBC
Phase C data receive byte count
AT+FREL
Phase C received EOL alignment
AT+FSPL Enable
polling
AT+FTBC
Phase C data transmit byte count
AT+FWDFC
Page width format conversion