Справочник Пользователя для Yamaha RX-V1900BL

■ Audio settings

E)AUDIO SET

TONE BYPASS

Use this feature to select whether the audio output 
bypasses the tone control circuitry when “TREBLE” and 
“BASS” are set to 0 dB (page 46).

HDMI AUDIO

Use this feature to select the types of the audio signals 
output at the HDMI OUT jack on the rear panel of this 
unit.

Available audio/video signals depend on the specification of the 
connected video monitor. Refer to the instruction manuals of 
your video monitor and audio source component.

■ Pure direct F)PURE DIRECT
Use this feature to select whether this unit outputs the 
video signals when this unit is in the Pure Direct mode.

You cannot use the OSD menu even if “PURE DIRECT” is set 
to “AUDIO+VIDEO”.

Use this feature to adjust the video parameters.

y

You can reset the all parameters in “VIDEO MENU” to the 
initial factory settings by using “VIDEO” of “INITIALIZE” in 
“ADVANCED SETUP” (page 103).

VIDEO CONV.

Use this feature to set whether to convert the video signals 
input at the VIDEO, S VIDEO, and COMPONENT 
VIDEO jacks.

• This unit does not convert 480 line video signals and 576 line 

video signals interchangeably.

• 480p-, 576p-, 1080i- and 720p-resolution video signals cannot 

be output at the S VIDEO and VIDEO MONITOR OUT jacks.

• The converted video signals are only output at the MONITOR 

OUT jacks. When recording a video source, you must make the 
same type of video connections between each component.

• When composite video or S-video signals from a VCR are 

converted into component video signals, the picture quality may 
suffer depending on your VCR.

• Unconventional signals input at the composite video or S-video 

jacks cannot be converted or may be output abnormally. In such 
cases, set “VIDEO CONV.” to “OFF”.

Component interlace/progressive up-conversion
COMPONENT I/P
Use this feature to activate or deactivate the analog 
interlace/progressive conversion of the analog video 
signals input at the composite video, S-video and 
component video jacks so that the analog video signals 
deinterlaced from 480i (NTSC)/576i (PAL) to 480p/576p 
are output at the COMPONENT MONITOR OUT jacks.

Automatically bypasses the tone control 
circuitry to provide the purest signal possible 
when “TREBLE” and “BASS” are set to 0 dB.

OFF

Does not bypass the tone control circuitry.

Outputs audio signals that can be decoded by 
this unit.

AMP+TV

Outputs audio signals that can be decoded by 
your video monitor connected to the HDMI 
OUT jack of this unit.

Does not Output video signals.

AUDIO+VID
EO

Outputs video signals. For the better sound 
quality, this unit only activates the limited video 
features.

Converts composite, S-video, and component 
video signals interchangeably and up-converts 
composite, S-video, and component video 
signals to HDMI video signals.

OFF

Does not convert any signals.

ON

Activates the analog interlace/progressive up-
conversion of the analog video signals.

Deactivates the analog interlace/progressive up-
conversion of the analog video signals.