Справочник Пользователя для Source Technologies sti micr st9335

Secure MICR Printer User’s Guide

©

 Source Technologies

July 2003

Page  20

All rights reserved

When entering MICR mode with the &%STH command, the printer will:

• Check to see if the proper Front Panel Combination has been entered (when

enabled).

• Allow access to secure check printing resources such as MICR fonts and secure

fonts which are stored in printer ROM.  It also allows access to protected
signatures, overlays, logos and other important resources stored in password
protected nonvolatile flash memory.

• Turn Hex Transfer ON.

NOTE: The &%STH command can occur within a datastream after the page has
started. The &%STH command, unlike the &%STF command, can be issued
anywhere on the page.

&%STF or &%STH

Lead in sequence

PASSWORD

User defined password, 8 characters, case sensitive,

unprintable characters allowed.  Factory default is

PASSWORD. See also New Password Command.

$

Command terminator

&%SMCPxxxx$    (optional)

&%SMCP

Lead in sequence

xxxx

MICR count, the number of MICR lines to be printed during

this print job. (4 bytes in hex)

$

Command terminator

Example:  &%SMCP0010$

Prints 16 (Hex 10) MICR lines before disabling MICR mode.  This command defines how
many MICR lines may print in the current job. When the count decrements to zero, MICR mode
is terminated.

&%STE

Lead in sequence

xxxxxxxx

New password, must be 8 characters either printable or non

printable.  Dollar ($) sign is an invalid password character.

$

Command terminator.

Section  6: MICR Features