Справочник Пользователя для AstroStart 502
502
5
START COMMANDS
START /STOP
(Options 2 & 3)
The Start-Stop command is in fact the reason for being of your remote starter. It allows you to start or stop
your vehicle without stepping outdoors.
The Start-Stop command is in fact the reason for being of your remote starter. It allows you to start or stop
your vehicle without stepping outdoors.
•
Press the
button once.
UPON STARTING
The parking lights will flash once to confirm the reception of the command, then will stay ON as long as the
engine will be running under remote control.
UPON STOPPING
The engine and parking lights will turn off.
The command is only applicable when engine is running under remote control.
The parking lights will flash once to confirm the reception of the command, then will stay ON as long as the
engine will be running under remote control.
UPON STOPPING
The engine and parking lights will turn off.
The command is only applicable when engine is running under remote control.
START
(Option 1 only)
To start the engine, press
To start the engine, press
button (lights: 1).
The system automatically adjusts ignition duration for your type of vehicle; parking lights flash once then
stay on all the time engine is running.
If more than one command is emitted, each successive start command resets runtime to the beginning,
parking lights flash once to confirm command has been received.
stay on all the time engine is running.
If more than one command is emitted, each successive start command resets runtime to the beginning,
parking lights flash once to confirm command has been received.
I
F ENGINE FAILS TO START
If your system cannot start the engine at first attempt, it will wait for a few seconds and then try again (it
could try again twice depending on reason for failure to start).
After three attempts, it will shut down automatically and wait for new command.
could try again twice depending on reason for failure to start).
After three attempts, it will shut down automatically and wait for new command.
W
HEN ENTERING YOUR VEHICLE
...
Do not apply brakes; this will stop engine immediately.
Insert ignition key and turn it to “ON” position.
DO NOT TURN IGNITION KEY TO
“START”
POSITION.
Drive as usual.
E
NGINE RUNTIME
Your engine will stop automatically after a preset time of 2 min.
, 4 min.
, 8 min.
or 18 min.
depending on settings during installation. Runtime doubles for diesel engine vehicles.
Parking lights will remain on for the whole running time period.
Parking lights will remain on for the whole running time period.