Справочник Пользователя для Zebra 50-12500-066

9 - 2

LI4278 Product Reference Guide

This connection is made directly from the cradle to the host interface.

To connect the IBM 46XX interface:

Attach the modular connector of the IBM 46XX interface cable to the host port on the bottom of the linear 
imager scanner cradle (see 

 or 

Connect the other end of the IBM 46XX interface cable to the appropriate port on the host (typically Port 9).

Select the port address by scanning the appropriate bar code from 

To modify any other parameter options, scan the appropriate bar codes in this chapter.

See 

 for information about linear imager scanner/cradle pairing 

and wireless communication

The linear imager scanner must be connected to the cradle for the host parameter setting to take effect. 
When the linear imager scanner is not connected to a cradle, and a host parameter bar code is scanned, 
a long low/long high beep sequence sounds.

Host Port Connector

Interface Cable

Power Supply

Interface cables vary depending on configuration. The connectors illustrated in 

 are examples 

only. The connectors may be different than those illustrated, but the steps to connect the cradle remain the 
same.

If a power supply is used, disconnect the power supply before changing host cables or the cradle may not 
recognize the new host.

The only required configuration is the port number. Other linear imager scanner parameters are typically 
controlled by the IBM system.