Справочник Пользователя для Atmel ATAK2270

4871E–RFID–04/08

Figure 5-12.  TK5551 Read Tab 

Selecting Transponder >TK5551 from the Setup menu, opens the the TK5530 user interface. Two tabs 
are available – Read and Write. The Read tab is divided into two areas – Configuration Setup and Read 
Timings. The following parameters can be configured in the Configuration Setup area:

„

Bitrate: Rf/8, 

Rf/16, 

Rf/32, Rf/40, Rf/50, Rf/64, Rf/100 and Rf/128

„

Coding: 

Manchester, Biphase, direct, PSK..., FSK,...

„

ID-Code Length: 

Block0, Block1, Block 1 to 2, Block 1 to 3, ..., Block 1 to 7

„

Signature: 

Header, Sequence Terminator, Block Terminator, and Block and Sequence 

 

Terminator

„

Password:

Selecting this check box activates password mode 

 

(see 

)

„

Lock Block 0: 

Selecting this check box locks the configuration block of the transponder. 

 

This means that the bit rate, coding, etc., are locked and cannot be changed.

 

Use this feature with care.

„

Stop-Mode enable: 

Obey stop command

„

Answer On Request: 

Activates anticollision mode (selecting this shows an additional button for AOR 

 

wake-up, see 

Note:

The base station IC U2270B does not support the reading of all bit rates and codings offered by the tran-
sponder type. If a non-supported mode is configured, a warning message will be displayed on the screen.