Справочник Пользователя для TEAC MCDV600

This setting is for selecting the output terminal of the video. You can 
select “S-VIDEO” (S-video output) or “Y Cb/Pb Cr/Pr” (Component 
video output).

Select this if you have connected the unit to your TV using S-Video 
jack.

Select this if you have connected the unit to your T V using 
Component video jacks.

< When your TV is connected to the HDMI terminal, no signal is 

output from the component video output jacks.

This setting allows the selection of interlaced (INTERLACE) or 
progressive-scan (PROGRESSIVE) video from the component video 
outputs.

Progressive-scan video provides a better, clearer picture. However, it 
is not supported by every TV or monitor, and you should ensure that 
this is supported fully before turning on this option.

<  When your TV is not compatible with progressive scanning, 

never select “PROGRESSIVE”. Otherwise, a picture is distorted 
or no picture will be shown on the monitor.
In case you select “PROGRESSIVE” by mistake, disconnect the 
connection of the MC-DV600 and the TV, and then connect in 
again. And change the setting to  “INTERLACE” in the VIDEO 
SETUP menu.

Consumers should note that not all high definition TV sets 

are fully compatible with this product and may cause artifacts 
to be displayed in the picture. In case of 480 (525) or 576 (625) 
progressive scan picture problems, it is recommended that the 
user switch the connection to the ‘standard definition’ output. If 
there are questions regarding our TV set compatibility with this 
model 480p (525p) and 576p (625p) DVD player, please contact 
our customer service center.

You can adjust some parameters of video picture.

  Highlight “COLOR SETTING” and press the right (t) 

  Use the left and right (g/t) buttons to select the 

SHARPNESS
This adjusts the sharpness of the picture shown on the monitor.
Select HIGH, MEDIUM or LOW using the Cursor buttons, then 
press the ENTER button.

BRIGHTNESS
This adjusts the brightness of the picture.
Use the left and right buttons to change the value from –20 to 
20, then press the ENTER button.

CONTRAST
This adjusts the picture contrast.
Use the left and right buttons to change the value from –16 to 
16, then press the ENTER button.

GAMMA
This adjusts the gamma value of the picture.
Select HIGH, MEDIUM, LOW or NONE using the Cursor buttons, 
then press the ENTER button.

HUE
This adjusts the green/red balance of the picture (only for 
progressive-scan output).
Use the left and right buttons to change the value from –9 to 9, 
then press the ENTER button.

SATURATION
This adjusts the saturation level.
Use the left and right buttons to change the value from –9 to 9, 
then press the ENTER button.

LUMA DELAY
This adjusts the luma delay.
Select 0 T or 1 T using the Cursor buttons, then press the ENTER 
button.

  Press the left (g) button to return to the VIDEO SETUP