Справочник Пользователя для Epson photopc 3000z
Introduction
7
❏
Unplug the charger after four hours of charging,
whether the batteries are fully charged or not.
whether the batteries are fully charged or not.
❏
Do not insert batteries into wall outlets or other power
sources such as car cigarette lighter sockets.
sources such as car cigarette lighter sockets.
❏
Do not solder lead wires or terminals directly to a
battery.
battery.
❏
To prevent fire or electrical shock, do not cover the
charger with a blanket or other covering that may give
off an electrical charge.
charger with a blanket or other covering that may give
off an electrical charge.
❏
If battery acid gets into your eyes or on your skin,
immediately rinse the affected area thoroughly with
water and seek medical treatment. If a battery is
swallowed, seek medical treatment immediately.
immediately rinse the affected area thoroughly with
water and seek medical treatment. If a battery is
swallowed, seek medical treatment immediately.
Safety information for United Kingdom users
w
Warning: This appliance must be earthed. Refer to
the rating plate for voltage and check that the
appliance voltage corresponds to the supply voltage.
the rating plate for voltage and check that the
appliance voltage corresponds to the supply voltage.
Important: The wires in the mains lead fitted to this
appliance are coloured in accordance with the
following code:
appliance are coloured in accordance with the
following code:
Blue — Neutral
Brown — Live
Brown — Live
As the colours of the wires in the mains lead of this
appliance may not correspond with the coloured
markings identifying the terminals in your plug,
proceed as follows:
appliance may not correspond with the coloured
markings identifying the terminals in your plug,
proceed as follows:
The blue wire must be connected to the terminal in the
plug marked with the letter N.
plug marked with the letter N.
The brown wire must be connected to the terminal in
the plug marked with the letter L.
the plug marked with the letter L.
If damage occurs to the plug, replace the cord set or
consult a qualified electrician.
consult a qualified electrician.
Replace fuses only with a fuse of the correct size and
rating.
rating.