Справочник Пользователя для Siemens siemens network router mc35

MC35_SAT_01_v02.00

Page 23 of 65

11.01.2002

Test command

AT^SSTGI=?

Response

^SSTGI:(list of supported <state>s), (list of supported <cmdType>s)

OK

Read command

AT^SSTGI?

Response

^SSTGI: <state>, <cmdType>

OK

Parameters

<state> 

Remote-SAT interface states (refer to AT^SSTA)

<cmdType> Ongoing Proactive Command (values see chapter 1.1.4

“Command Type Values”). However, this information is valid during
states PAC and WAIT only.

Write command

AT^SSTGI=

<cmdType>

There are two situations for use of the Write command:

1.  Regularly the Write command is used upon receipt of an unsolicited result

code ^SSTN:<cmdType>.
In this case the TA is expected to acknowledge the ^SSTGI response with
AT^SSTR to confirm that the proactive command has been executed.
AT^SSTR will also provide any user information e.g. selected menu item.

2.  There may be the situation to request the information via AT^SSTGI without

previously receiving an URC ^SSTN:<cmdType>.
This will always be the case if the TA has started or restarted its application
(e.g. a MMI) after power on the ME.
To request the information despite the probably missed URCs it is possible
to issue AT^SSTGI during states IDLE, PAC and WAIT at any time for the
following Proactive Commands:
PAC type   5: Set Up Event List,
PAC type 37: Setup Menu,
PAC type 40: Setup Idle Mode Test.

Note:
In case of using the Write command without receipt of an unsolicited result
code ^SSTN:<cmdType> it is neither necessary nor possible to
acknowledge the ^SSTGI response with AT^SSTR.
Such a ^SSTGI response will not cause any state changes.

The command type value is returned to the ME to identify which ^SSTN is being
responded to.

Reference

Siemens

Note