Справочник Пользователя для Tecumseh lh318xa

Скачать
Страница из 24
181-630-14
Four-Cycle Engine • L-Head • Horizontal Crankshaft • Air-Cooled
Page 11
When pulling starter rope, the rope 
can unexpectedly jerk back toward 
engine causing serious injury. To avoid this risk, carefully 
follow these instructions:
5.
Grasp starter cord handle. See Figure 29.
a. Pull rope out slowly until you feel drag.
b. Next, pull rope with one rapid full arm stroke.
c. Return rope slowly to original position.
 NOTE
Following the instructions listed in the steps above avoids 
potential damage to the recoil mechanism.
6.
When engine starts:
a. Momentarily move Choke Control to “1/2 CHOKE” 
position until engine runs smoothly. See Figures 27 
and 28.
b. Next, move Choke Control to “NO CHOKE” position. 
7.
Move Engine Speed Control to desired speed in “RUN” 
range. See Figure 26.
 NOTES
If engine starts but falters when Choke Control is moved to 
“NO CHOKE” position:
a. Momentarily move Choke Control back to “FULL 
CHOKE” position. 
b. Next, move Choke Control to “1/2 CHOKE” position 
until engine runs smoothly.
c. Finally, move Choke Control to “NO CHOKE” 
position. 
8.
If engine dies after Choke Control is to moved to “NO 
CHOKE” position repeat steps 2 thru 7 to restart 
engine.
9.
If engine fires but does not continue to run, move 
Choke Control to “NO CHOKE” position and start 
engine. 
10. If engine fails to start after 3 attempts in the “NO 
CHOKE” position, move Choke Control to “FULL 
CHOKE” position and start engine.
11. If engine does not start after following steps 1 thru 10, 
contact your Authorized Tecumseh Servicing Dealer. 
DO NOT attempt to start or troubleshoot this engine in 
any other way.
!
WARNING
Figure 27. Horizontal Mounted Choke Control
Figure 28. Vertical Mounted Choke Control
Figure 29. Starter Cord Handle
1. Full Choke Position
2. 1/2 Choke Position
3. No Choke Position 
1
2
3
1. Full Choke Position
2. 1/2 Choke Position
3. No Choke Position 
1
2
3