Справочник Пользователя для Alliance Laundry Systems sc50

57

F232062

The machine should be cleaned after 
the installation is complete. A function test 
should then be executed on the unloaded 
machine:

1. Check the power supply for such 

characteristics as correct voltage, phase, 
and cycles to be certain they are correct for 
the machine.

2. Open manual shut-off valves to 

the machine.

3. Turn on electric power.

4. Check the door interlock before starting 

operation:

a. Open the loading door.

For coin-operated machines, press the 
round button on the door handle and 
turn the door handle downward.

For machines intended for use in 
on-premises laundries, press and hold 
the door-unlock button on the left side 
of the control panel. Press the round 
button on the door handle and turn the 
door handle downward.

b. Attempt to start the machine with the 

door open. The machine should not 
start with the door open.

c. Close the door without locking it and 

attempt to start the machine. The 
machine should not start with the 
door unlocked.

d. Close and lock the door and start a 

cycle. Attempt to open the door while 
the cycle is in progress. The door 
should not open.

If the door lock and interlock are 
not functioning properly, call a 
service technician.

5. Run a complete cycle, checking operation 

of water inlet valves, drain, and 
extract functions.

6. Cylinder rotation must be 

counterclockwise in the extract step. If 
rotation is not counterclockwise in the 
extract step, disconnect power. For 
variable-speed models, have a qualified 
electrician reverse any two motor leads 
at the AC drive terminal block (terminals 
U, V, and W). See Figure 48. For 
2-speed and 3-speed models, have a 
qualified electrician use the wiring 
diagram included with the machine to 
determine which input power leads 
should be switched.