Справочник Пользователя для Siemens HIPATH 5000
Introduction and Important Notes
Nur für den internen Gebrauch
A31003-G2540-A100-3-76A9, 04/2003
1-8
optiClient 130 V4.0, User Manual
1einl.fm
Safety Information
●
Install cables in such a way that they do not pose an accident risk (by people tripping over
them) and also so that they are not damaged.
them) and also so that they are not damaged.
1.3.4
General Notes
●
If the installation is brought into the operating site from a cold environment, condensation
may occur. Wait until the temperature of the installation has adjusted to the ambient tem-
perature and make sure that the system is absolutely dry before you start it.
may occur. Wait until the temperature of the installation has adjusted to the ambient tem-
perature and make sure that the system is absolutely dry before you start it.
●
Before starting a wall assembly, check whether the load-bearing capacity of the wall is ad-
equate, e.g., in the case of dry walls.
equate, e.g., in the case of dry walls.
●
When maintenance work has been completed, always re-install all safety equipment in the
right place. Also close all doors, covers, or the housing after completing test and mainte-
nance work.
right place. Also close all doors, covers, or the housing after completing test and mainte-
nance work.
●
All cables and lines which leave a system cabinet must be shielded at least between the
connection point in the cabinet and the point at which the cable leaves the cabinet.
Use a clip and pressure screw to contact all shield fabric to the cabinet outlet. This also
applies to permanently connected service equipment.
connection point in the cabinet and the point at which the cable leaves the cabinet.
Use a clip and pressure screw to contact all shield fabric to the cabinet outlet. This also
applies to permanently connected service equipment.
●
Connect all cables only to the specified connection points.
●
Do not install any external modems in the installation cabinets.