Справочник Пользователя для Philips dvp320
8
Preparation
Replacing battery (lithium
CR2025) into the remote control
CR2025) into the remote control
1
Pull out the lithium battery
compartment A.
compartment A.
2
Replace a new battery and fully insert
the battery compartment back to the
original position.
the battery compartment back to the
original position.
CAUTION!
–
Insert the plastic protective sheet if they
are exhausted or not to be used for a long
time.
–
time.
–
Batteries contain chemical substances,
so they should be disposed off properly and
kept away from children.
kept away from children.
Using the Remote Control
●
Pull out the plastic protective sheet
which is used to keep the lithium
battery fresh.
which is used to keep the lithium
battery fresh.
● Direct the remote control at the
remote sensor of the DVD player.
● Do not drop or give the remote
control a shock.
●
Do not leave the remote control in extremely
hot or humid places.
hot or humid places.
● Do not spill water or put anything wet on the
remote control.
Connecting the Power Supply
1
Plug the female end of the power cable supplied
into the power connector on the rear of the
player.
into the power connector on the rear of the
player.
2
Plug the male end of the cord into an AC outlet.
Note: When the DVD player is switched to
Standby mode, it is still consuming some power. If
you wish to disconnect your player completely from
the mains, withdraw the plug from the AC Outlet.
Standby mode, it is still consuming some power. If
you wish to disconnect your player completely from
the mains, withdraw the plug from the AC Outlet.
Switching On
1
Be sure that the DVD player has been correctly
connected to the TV and audio equipment.
connected to the TV and audio equipment.
2
Switch on the TV and DVD player.
3
Set the TV to the correct Video In channel. (eg.
EXT1, EXT2, AV1, AV2, AUDIO/VIDEO, etc.
EXT1, EXT2, AV1, AV2, AUDIO/VIDEO, etc.
Please refer to your TV owner's manual for
details.)
details.)
➜ The player display lights and the default screen
appears on the TV.
appears on the TV.
4
If you are using an external equipment (eg. audio
system or receiver), turn it on and select the
appropriate input source for the DVD player
output. Refer to the equipment owner’s manual
for detail.
system or receiver), turn it on and select the
appropriate input source for the DVD player
output. Refer to the equipment owner’s manual
for detail.
Smart Power On/Off
When in STOP or NO DISC mode, the DVD
player will switch to standby mode after 15
minutes without any operations for saving energy.
It is easily reactivated by pressing the POWER or
PLAY key on the remote control or the PLAY
button on the front panel.
player will switch to standby mode after 15
minutes without any operations for saving energy.
It is easily reactivated by pressing the POWER or
PLAY key on the remote control or the PLAY
button on the front panel.
LITHIUM BATTERY
DC - - - 3V CR2025
CR2025
+
+
3 V
CR
2025
LITHIUM BATTERY
DC - - - 3V CR2025