Справочник Пользователя для Philips lx9000r-22s
WARNING
Under no circumstances should you try to repair the set yourself as this
will invalidate the guarantee. Do not open the set as there is a risk of
electric shock.
will invalidate the guarantee. Do not open the set as there is a risk of
electric shock.
If a fault occurs, first check the points listed before taking the set for
repair. If you are unable to solve a problem by following these hints,
consult your dealer or service centre.
repair. If you are unable to solve a problem by following these hints,
consult your dealer or service centre.
Laser safety
This unit employs a laser. Only a qualified service person should remove
the cover or attempt to service this device, due to possible eye injury.
the cover or attempt to service this device, due to possible eye injury.
Problem
Solution
No power
– Make sure the mains cable is connected properly.
– Press 2 STANDBY•ON on the set to switch it on.
– Press 2 STANDBY•ON on the set to switch it on.
No reaction to controls and
– The set is in initial installation mode: Switch the TV on, switch over to the
15 TV ON? indication
DVD recorder system socket.The menu for language selection appears.
Continue as described in the chapter “Basic settings”.
Continue as described in the chapter “Basic settings”.
Set does not work
– The DVD recorder system has become too hot and the overheating safety
and is in standby
circuit has been activated. Let the DVD recorder system cool down, then
press 2 to switch it on again.
press 2 to switch it on again.
No reaction to controls
– Check the power supply.
– Disconnect the set from power supply, reconnect after 30 seconds.
– Reset the set to the default factory settings: All the information stored
– Disconnect the set from power supply, reconnect after 30 seconds.
– Reset the set to the default factory settings: All the information stored
(programmes, time and date) will be lost.
1
Disconnect the set from power supply.
2
Press and hold down 2 STANDBY•ON on the set and reconnect the
set.
set.
3
As soon as
15 TV ON? is displayed, release 2 STANDBY•ON.
4
Continue as described in chapter “Basic settings”.
Remote control does not function
– Point the remote control towards the set.
properly
– Remove batteries, wait 10 seconds and insert them correctly or insert new
batteries.
– Reduce distance to the set.
– The remote control has been switched to control an external appliance.
– The remote control has been switched to control an external appliance.
Briefly press DVD/MON or TUNER to control the DVD recorder or the
radio tuner.
radio tuner.
Demo mode is on
– Keep STOP
9 pressed for at least 5 seconds to cancel the demo mode.
External appliance not selectable
– The selected appliance is not installed on the DVD recorder system. Please
and
INSTALL SOURCE is scrolled
see “When adding appliances or changing the connections of appliances” on
how to install it.
how to install it.
Troubleshooting
62
English