Справочник Пользователя для Philips showview dvdr3380
English
58
Troubleshooting
Problem
(General)
Solution
WARNING
Under no circumstances should you try to repair the system yourself, as this will
invalidate the warranty. Do not open the system as there is a risk of electric shock.
Under no circumstances should you try to repair the system yourself, as this will
invalidate the warranty. Do not open the system as there is a risk of electric shock.
If a fault occurs, fi rst check the points listed below before taking the system for repair.
If you are unable to remedy a problem by following these hints, consult your dealer or
Philips for help.
If you are unable to remedy a problem by following these hints, consult your dealer or
Philips for help.
No power.
Remote control does not
work.
work.
No picture.
No sound.
No TV signal received from
the recorder.
the recorder.
A TV channel installed during
the DVD recorder’s
automatic TV channel search
is fuzzy or distorted.
the DVD recorder’s
automatic TV channel search
is fuzzy or distorted.
Unable to eject tray
– Press STANDBY-ON button on the front of the recorder to
switch on the system.
– Make sure the AC outlet has power.
– Aim the remote control directly at the sensor on the front of
the DVD recorder (not towards TV).
– Remove any obstacles between the recorder and the remote
control. Aim the remote control towards the set at different
angles and/or distances.
angles and/or distances.
– Batteries are weak, replace the batteries.
– Press REC SOURCE on the remote control to select an input
– Press REC SOURCE on the remote control to select an input
source.
– Switch on your TV and set to the correct Video In channel.
Switch the TV channel until you see the DVD screen. Read
chapter “Step 3 - Installation and Setup – Finding the correct
viewing channel” for details.
chapter “Step 3 - Installation and Setup – Finding the correct
viewing channel” for details.
– Check the video connection between the recorder and the TV.
– Check the audio connections, the red and white sockets. Read
chapters “Step 1 : Basic Reorder Connections - Connecting the
audio cables” for details.
audio cables” for details.
– Set the Digital output correctly, based on the equipment you
connected to the recorder. Read chapter “DVD System Menu
Options - PLAYBACK settings – Digital Audio Output” for
details.
Options - PLAYBACK settings – Digital Audio Output” for
details.
– Have your aerial or cable TV signal checked.
– Install the TV channel. Read chapter “Step 3: Installation and
– Install the TV channel. Read chapter “Step 3: Installation and
Setup - Setting your TV channel programmes” for details.
– Check the video connection between the DVD recorder and
the TV.
– You can further fi ne-tune the signal of the TV channel. Read
chapter on “DVD System Menu Options – CHANNEL SETUP
Settings”
Settings”
– Press CH +/– to search for the same TV channel which may
have a clearer picture.
– Exit from any on-screen menu until you see the Philips
wallpaper
– Press STOP to stop any playback or recording, then press
EJECT on the set.