Справочник Пользователя для Pelco C579M

BASIC SYSTEM EXAMPLE

CM9760-SAT

 Software version 7.80.003 and greater supports 

 of PTZ capable cameras through the Genex multiplexer. The first

example briefly addresses this in relationship to a 9760-SAT system environment. Programmed, Genex related, 9760 configuration files are
used in Example 1, but are discussed and illustrated in Example Two, Part I.

 The second example discusses, in greater detail than is used in Example 1, the connections and programming requirements

necessary for the operation of 

  from either the 

  and/or the 

  within a 9760-SAT system

environment. These functions are keyboard activated, using icon-labeled references to call up multiple screen displays generated by the
Genex. The 

 operator uses the KBD200,300,or 300Vs. The 9760 operator uses the 9760-KBD.

Consider the illustration in Figure 4-4

In the above Figure, note the following:

1.

Camera inputs to the Genex are looped and serve as corresponding inputs to the CM9760-SAT.

2.

A video path is available to any operator on either side of the configuration to all Genex attached cameras, including  Spectra input 1. For
the 

 operator, access exists through the looped input from the Genex; for the 9760 operation, it exists through the same path via the

tie line connections between the 

 and the MXB.

3.

You must also (as a minimum), configure the Genex for the following (consult the Genex manual for further details):

a.

Set video termination. This can be done globally in the System Setup menu (hold the VIEW button down for two seconds) or it can be
done on a per-camera basis in the Camera menu (hold the associated CAM button down for two seconds). In our example, the inputs
for all cameras to the Genex should be set for 

.

b.

Camera protocol should be set to 

 format via the Camera menu.

c.

The Unit ID should be set to 

 and the COMM TYPE setting (both accessed through the Advanced Menu selection) should be set to

.

Camera Control Through the Genex