Справочник Пользователя для Pelco C2403M-C

 

6

C2403M-C (10/05)

 

Follow the proceeding steps when feeding wire/cables through the base of the cover and back box: 

1. Using the cover as a template, mark one 

of the large hole positions onto the 
mounting surface.

2. Cut out the hole in the mounting surface 

for power and video wiring.

3. Pull video and power wires through the 

hole in the cover.

4. Attach the cover to the mounting surface 

(hardware not supplied). Use stainless 
steel hardware when installing the 
system outdoors.

5. Connect the video cable.

6. Connect the power wires.

•

For 12 VDC, connect the 24 VAC/12 
VDC (red) and GND (black) wires to 
input power.

•

For 24 VAC, connect the 24 VAC/12 VDC (red) and 24 VAC (blue) wires to input power.

7. Install the back box inside the cover. Rotate and position the back box so that the conduit plug 

on the side of the box is located on the opposite side (180 degrees) from the notch on the side 
of the cover. Use the supplied 8-32 x 0.375-inch screws and washers to secure the back box to 
the cover.

 

 For vandal-resistant installations, the conduit plug located on the side of the back box should 

be hidden if it is not used. To hide the conduit plug rotate the back box so that the plug is located on 
the opposite side (180 degrees) from the notch on the side of cover.

COVER

BACK BOX