Справочник Пользователя для Pelco C538M-A
Pelco Manual C1503M (11/99)
9
5.
Change the command line in the autoexec.bat file to reflect the new flat files name:
from TEST to
from TEST to
newfilename
(the name you chose in step 2 above).
6.
Click
File
, then
Save
.
7.
You also need to change the test.bat file to reflect the new flat files name, otherwise
the system will not run. Click
the system will not run. Click
File
, then
Open
.
8.
Click on
newfilename
.bat
in the 9760 directory, then
Ok
.
9.
Change the command line in the
newfilename
.bat file to reflect the new flat files name:
from CM9760 TEST to
CM9760
newfilename
(the name you chose in step 2 above).
10. Click
File
, then
Save
.
11. Click
File
, then
Exit
to leave the file editor.
12. Re-boot the system (by simultaneously pressing
Ctrl/Alt/Delete
) for the changes to
take effect.
VERIFYING OPERATION
1.
Power up all the remaining equipment. After the CM9760-CC1 loads the configuration
files, the CM9760-KBD LCD should show “SYSTEM 9760.”
files, the CM9760-KBD LCD should show “SYSTEM 9760.”
2.
Enter
1111
(the keyboard #1 default password) on the CM9760-KBD keypad. The as-
terisks on the keyboard will move one space to the left for each number entered. The
LCD will display “ENTER MONITOR #.”
LCD will display “ENTER MONITOR #.”
3.
Enter
1 MON
.
4.
Press the
FWD
key to step through the cameras and verify switching.
The default password for keyboard 2 is 2222, keyboard 3 is 3333, etc.
APPENDIX
SYSTEM PORT SETTINGS TABLE
See the following page.