Справочник Пользователя для Pelco EM1900U

To attach the mount, perform the following steps:

1.

Determine the location where the mount is to be installed.

2.

Using the mount as a template, mark and drill holes in the mounting surface.

3.

Bring the wiring in from the cable hole in the mounting plate or the side of the mount near
the mounting plate and through the mount arm.

4.

Attach the mount securely with four 1/4-20 fasteners (not provided) of appropriate length.
When installing the mount outdoors, seal the mounting holes with an appropriate sealant.
Apply the sealant around the holes between the mount and the mounting surface.

5.

Attach the enclosure or camera securely with the two 1/4-20 x 0.625-inch (1.588 cm) hex
bolts provided.

6.

Loosen the bolts on the swivel head and position as desired. Tighten bolts and lock into
place.

7.

Make all necessary electrical connections to the enclosure and camera (refer to the
manuals provided with the enclosure and camera.)

Make

certain that the mount-
ing surface is capable

of supporting four times the full
load of the mount, enclosure,
and camera.

If you need replacement parts, obtain a service manual in one of the following ways:

•

Go to Pelco’s web site at ftp://www.pelco.com and find service manual C202SM.

•

Contact Pelco’s Literature Department and request service manual C202SM.