Справочник Пользователя для Pelco MC3600H-2

[ 6 ] 

      Pelco Manual C1982M-A (12/00)

CAMERA LAYOUT

Figure 1. Camera Layout

NOTE: The cosmetic trim ring conceals the LED light for more discreet surveillance operations.

The trim ring also hides the power connectors and protects the DIP switches.

INSTALLATION

Lens Mounting

The MC3500 and MC3600 Series cameras can use fixed iris, manual iris, auto iris, or direct drive
lenses. Cameras are factory-set for CS-mount lenses, but easily adjusted for C-mount lenses.

1. C-Mount Lens Only - Loosen the two back focus locking screws. Rotate the back focus

adjustment ring fully counterclockwise before installing the C-mount lens (refer to the section on

 

).

2. Remove the cosmetic trim ring from the back of the camera (refer to Figure 1). Set the lens mode

selector switch on the side of the camera to AI (auto iris video drive lens)or DD (auto iris DC drive
lens). Refer to the 

 section. Switch setting is determined by the type of lens used.

3. Screw the lens onto the lens mount. Be careful to prevent dust from entering the space between the

lens and the CCD element. If necessary, use clean, compressed air to remove any foreign matter.

4. Thread the lens cable through the cosmetic trim ring.

5. Connect the direct drive (DD) or auto iris (AI) lens to the 4-pin iris drive connector located on the

side of the camera. Refer to Figure 2 for the pin connections for the iris drive connector.

BACK FOCUS

ADJUSTMENT

RING

BNC VIDEO CONNECTOR

LENS CONNECTOR

DIP SWITCHES

LED

MOUNT ADAPTER

PHASE ADJUSTMENT

LEVEL ADJUSTMENT

POWER SUPPLY

BACK FOCUS

ADJUSTMENT

LOCKING

SCREW

COSMETIC TRIM

RING