Справочник Пользователя для Metrologic Instruments IS4220
14
D
EFAULT
S
ETTINGS
Many functions of the scanner can be "programmed", that is enabled or
disabled. The scanner is shipped from the factory programmed to a set of
default conditions. All factory default parameters have an asterisk ( * ) in the
default column of the charts on the following pages . If an asterisk is not in the
default column then the setting is off or disabled by default. Every interface does
not support every parameter. If the interface supports a parameter listed in the
charts on the following pages, a check mark ( ) will appear.
P
ARAMETER
D
EFAULT
RS232
L
IGHT
P
EN
K
EYBOARD
W
EDGE
USB
Enter Program Mode After Any Scan
*
Enter Program Mode Only on
First Scan
First Scan
Short Range Activation
Long Range Activation
*
Normal Scan
*
Pulsing Scan
Custom Scan
Short Same Symbol Rescan
Long Same Symbol Rescan
*
Alternate Beeper Tone 1
Alternate Beeper Tone 2
*
Alternate Beeper Tone 3
No Beeper Tone
Two Second Timeout
No Two Second Timeout
*
Razzberry Tone on Timeout
No Tone on Timeout
*
Three Beeps on Timeout
Beep Before Transmit
*
Beep After Transmit
Baud Rate
9600
Parity
Space
8 Data Bits
7 Data Bits
*
RTS/CTS
Character RTS/CTS
*
Message RTS/CTS