Справочник Пользователя для Metrologic Instruments MS1690

 

 

9

I

NSTALLING THE 

S

CANNER TO THE 

H

OST 

S

YSTEM

 

 
1.  Turn off the host device.  

 

2.  Plug the male 10-pin RJ45 end of 

the PowerLink cable into the 10-pin 
socket on the Focus.  You will hear a 
‘click’ when the connection is made. 

 

3.  Plug the other end of the 

communication cable into the host’s 
keyboard port. 

 

4.  Plug the external power supply into 

the power jack on the PowerLink 
cable.  

 

Check the AC input 
requirements of the power 
supply to make sure the 
voltage matches the AC 
outlet.  The outlet must be 
located near the equipment 
and be easily accessible. 

 

5.  Connect AC power to the transformer.  

 

6.  Focus will start to initialize.  All LEDs (yellow, white, and blue) will light for 

approximately 2 seconds then start to alternately flash.  When the scanner 
has finished initializing the LEDs will stop flashing and the unit will beep  
3 times indicating that the scanner is ready for use. 

 

7.  Turn on the host device. 
 

Plugging the scanner into a port on the host device does not guarantee 
that scanned information will be communicated properly to the host 
device.  The scanner is shipped from the factory configured with default 
settings.  Please refer to the MetroSelect Single-Line Configuration 
Guide (

MLPN 

00-02544) or MetroSet2’s help files for instructions on 

changing the scanner’s configuration.  In addition, please check that the 
scanner and host system are using the same communication protocol.   

 

Caution:  
To maintain compliance with applicable standards, all circuits connected to the scanner must 
meet the requirements for SELV (Safety Extra Low Voltage) according to EN/IEC 60950. 

 

To maintain compliance with standard CSA-C22.2 No. 60950-00/UL 60950 and norm EN/IEC 
60950, the power source should meet applicable performance requirements for a limited 
power source.