Справочник Пользователя для Magma PCI to PCI Interface

 

Connect all power cords to the power-in receptacle located at the rear of 
the enclosure.   

Secure the cable to the computer with the captive thumbscrews. 
It is important that the cable be attached securely to the 
connectors at both ends. 

If you purchased the “half-height” PCIHIF64LP because your host 
computer is a low-profile chassis and you need to connect it to a 
32-bit expansion chassis, be sure to connect your expansion 
cable to the 32-bit (Teal) side of the host card. 

Finish connecting the power cable to your expansion system 
using instructions contained in the Expansion Chassis User 
Guide. Turn on the power to the expansion system first, and then 
the host computer.  

 

You must apply power to the Magma expansion chassis BEFORE you 
power up your computer. This will allow the higher numbered PCI buses 
in the PCI bus hierarchy to be at a stable state when the host system 
issues its master power-on bus reset. In systems that perform automatic 
PCI bus configuration, this will allow the configuration code to recognize 
the PCI bus hierarchy and any attached devices.  

There is an On/Off switch on the expansion chassis, as well as an LED 
indicator to indicate power status. For information about your particular