Справочник Пользователя для omnitron-systems-technolo 10-100m2
2.0
PORT STRUCTURE
2.1
OVERVIEW
The front panel of the 10/100M2 provides access to the management (serial console), UTP and fiber ports.
The fiber port will vary depending on the connector type; ST, SC, MT-RJ, LC or SFP supporting
100BASE-FX transceivers. The plug-in module features two additional Ethernet ports for connectivity
via the chassis backplane.
The fiber port will vary depending on the connector type; ST, SC, MT-RJ, LC or SFP supporting
100BASE-FX transceivers. The plug-in module features two additional Ethernet ports for connectivity
via the chassis backplane.
Fiber Port
Management Port
UTP Etherent Port
Fiber Port
UTP Etherent Port
Management Port
2.1.1
Management Port
PI
SA
The 10/100M2 features a Serial RS-232 Console Port (aka Craft Interface) which can be connected to a
computer for initial setup and configuration. The Serial Console Port is accessed through the mini DIN-6
female DCE interface. Connect the interface to a computer’s DB-9 serial port using the mini DIN-6 male
to DB-9 female cable adapter (Part # 8082-0), which is included with the 10/100M2.
computer for initial setup and configuration. The Serial Console Port is accessed through the mini DIN-6
female DCE interface. Connect the interface to a computer’s DB-9 serial port using the mini DIN-6 male
to DB-9 female cable adapter (Part # 8082-0), which is included with the 10/100M2.
An optional DB-9 male to female straight-through serial cable is available for extension (Part # 8081-3).
2.1.2
UTP and Fiber Ports
PI
SA
The UTP Ethernet port supports 10BASE-T and 100BASE-TX protocols, auto-negotiation and manual
forced modes for half and full duplex. The UTP port can be enabled or disabled via network management.
A disabled port will still connect and allow 802.3ah OAM communication, but blocks normal data traffic.
forced modes for half and full duplex. The UTP port can be enabled or disabled via network management.
A disabled port will still connect and allow 802.3ah OAM communication, but blocks normal data traffic.
The fiber interface supports the 100BASE-FX protocol. The fiber interface operates in manual mode and
supports half or full duplex operation. The fiber port can be enabled or disabled via network management.
A disabled port will still connect and allow 802.3ah OAM or IP-less (secure) OAM communication, but
blocks normal data traffic.
supports half or full duplex operation. The fiber port can be enabled or disabled via network management.
A disabled port will still connect and allow 802.3ah OAM or IP-less (secure) OAM communication, but
blocks normal data traffic.
2.1.3
Backplane Ethernet Ports
PI
The plug-in module supports two additional 10/100Mbps Ethernet Backplane Ports. The Backplane Ports
A and B allow Ethernet data connectivity between adjacent modules in an iConverter chassis. The two
backplane ports can be disabled or enabled via a DIP-switch or network management.
A and B allow Ethernet data connectivity between adjacent modules in an iConverter chassis. The two
backplane ports can be disabled or enabled via a DIP-switch or network management.
The iConverter 19-Module, 5-Module, 2-Module and 1-Module Redundant Chassis backplanes provide
ethernet data connectivity between adjacent slots or ports. The A and B backplane ports connect the slots
as illustrated.
ethernet data connectivity between adjacent slots or ports. The A and B backplane ports connect the slots
as illustrated.
Page 4