Справочник Пользователя для Frigidaire 137168200a

9



For pedestal installations, see additional installation 

instructions included with the pedestal.

raise

lower

Excessive noise and vibration can be prevented by 

properly leveling the washer.
  1  For free standing installation and with the washer 

within 4 feet (1 m) of its final location, place a level 

on top of the washer. 

  2  Use adjustable pliers to adjust the leveling legs so 

the washer is level front-to-rear and side-to-side, 

and stable corner-to-corner.

  3  Press down on alternate corners and sides and feel 

for the slightest movement. Adjust the appropriate 

leg(s) so the washer sits solidly on the floor on 

ALL four legs.  Keep the leveling leg extension at a 

minimum for best performance of the washer.

  1  Run some water from the hot and cold faucets to 

flush the water lines and remove particles that might 

clog the water valve screens and to determine which 

faucet is hot and which is cold supply.

  2  Remove the inlet hoses and rubber washers from the 

plastic bag located in the drum of the washer and install 

the rubber washers in each end of the inlet hoses.

  3  Connect the HOT inlet hose to the HOT inlet 

connection on the washer and the COLD inlet hose to 

the COLD inlet connection on the washer. Tighten by 

hand until snug. Then tighten each supply connection 

another 2/3 turn with pliers. Do not cross thread 

  4  Connect the HOT inlet hose to the HOT water 

supply and the COLD inlet hose to the COLD water 

supply. Tighten by hand until snug. Then tighten 

each supply connection another 2/3 turn with pliers.

  5  Turn on the water and check for leaks.

RUBBER WASHERS

MUST BE PRESENT

COLD

HOT