Справочник Пользователя для Mitel 8622

Скачать
Страница из 80
Mitel
®
 8620/8622 IP Phone User Guide – Issue 14, June 2010
Page 37
Call Features
Ending a Conference and Placing all Parties on Hold
You can end a conference and place all conference parties on Individual Hold, allowing you to 
toggle between the held parties and speak to one party at a time.
To end a conference and place all parties on Individual Hold: 
Press the CNF button, and then press 
 (Hold). CONFERENCE PARTIES ON HOLD 
appears. 
To toggle between the held callers:
Press 
 (Hold) twice for internal parties or the flashing CALL button for external parties.
Using Record-A-Call
You can use Record-A-Call to record an ongoing call as a mailbox message.
1
 You can then 
retrieve the message from your voice mailbox. The Record-A-Call feature stays active after the 
other party hangs up, so you can add to the recorded call with your own message.
To use Record-A-Call:
1.  While on a call, press 
 (Special), and then dial 385 to turn Record-A-Call on. 
REQUESTING RECORD-A-CALL appears.
2.  Enter the voice mailbox number where you want the recording saved. RECORD-A-CALL 
IN PROGRESS appears, and both you and the calling party hear a confirmation tone (if 
enabled).
To stop Record-A-Call:
Do one of the following:
 •
Press 
 (Special), and then dial 385.
 •
Hang up. 
Using Group Listen
You can use Group Listen to activate the speaker while you use the handset or headset to 
continue speaking. This allows other people to hear the other party on the call while the other 
party can only hear you (through the handset microphone). You cannot use Group Listen in 
Handsfree Mode. 
To use Group Listen:
While on a call, press 
 (Special), and then dial
 
312 to turn group listen on. GROUP 
LISTEN ON appears, and you hear a confirmation tone. The other party does not hear 
the confirmation tone. Dial 312 again to turn Group Listen off. 
1.
This feature may or may not be enabled for your system. 
NOTE
Record-A-Call is not supported on peer-to-peer (P2P) calls. Contact your system 
administrator for more information.
NOTE
If your system administrator assigns the Record-a-Call voice mailbox 
destination, you do not need to enter the voice mailbox number.
NOTE
If are using the handset, the 
 (Speaker) button lamp is unlit, even though the 
speaker is on. However, if you are using a headset, the 
 (Speaker) button lamp 
is lit. If you press   (Speaker) while on either the handset or headset you 
disconnect the call.