Справочник Пользователя для Mitel sx-200 5330

Mitel 5330/5340 IP Phones – User Guide 

To display the call log:  

1. Using 

the 

Settings key, program a Call 

History feature key. (see page 18 for key 
programming instructions.) The Call History 
feature key illuminates when call history is 
present. 

1. Press 

the 

Callers softkey to display the 

number of old calls and new calls. (Note: 
this key is only available when call 
history data is present.) 

2. Press 

Call History to display the number of 

old calls and new calls. Press New Calls to 
view calls that have arrived since your last 
review or press Old Calls to view 
previously-viewed calls 

2. Press 

New Calls to view calls that have 

arrived since your last review or press 
Old Calls to view previously-viewed 
calls. 

3. Press 

Delete to delete the current call. 

Press Delete All to delete all call logs. 
Press Call to return the call. 

3. Press 

Delete to delete the current call. 

Press Delete All to delete all call logs. 
Press Call to return the call. 

 

 

Call Park  
The Call Park feature allows you to place a call in a special hold state. You, or someone else, can 
then retrieve the call from any extension in the system.  

After parking the call, the system can automatically connect you to paging equipment so that you 
can announce the call to the requested party.  

To park an active call:  

1.  Do one of the following: 

•  Press the key that you have programmed as Call Park. 
• Press 

 (TRANS/CONF), and then dial the appropriate feature access code. 

The display shows PARKED@, followed by the park destination and parking spot 
index (if applicable). Example: PARKED@ 1234 @ 02.  

2.  Dial the directory number on which to park the call (not required if the number is 

programmed to the Call Park feature key). 

3.  To inform a user that a parked call is waiting, do one of the following: 

•  If automatic paging is enabled, announce the call and the park retrieve digits 

shown on the display.  

•  If automatic paging is disabled, press the programmed Page key, or dial the 

appropriate feature access code, followed by the Paging zone number (if 
required). Then, announce the call and park retrieve digits shown on the display.  

Note: Paging over a loudspeaker is not permitted in handsfree mode; you must use the handset 
or headset.  

To retrieve a parked call:  

1.  Dial the "Call Park Orbit Retrieve" feature access code.  

2.  Dial the two-digit orbit number. 

To answer a call that is ringing at another extension in your Pickup Group: