Справочник Пользователя для Motorola 7.7.4
242
set pinhole name name internal-port [ 0 - 65535 ]
Specifies the por t number your Motorola Netopia® Gateway should use when for warding
traffic of the specified type. Under most circumstances, you would use the same number
for the external and internal por t.
traffic of the specified type. Under most circumstances, you would use the same number
for the external and internal por t.
PPPoE /PPPoA Settings
You can use the following commands to configure basic settings, por t authentication set-
tings, and peer authentication settings for PPP inter faces on your Motorola Netopia® Gate-
way.
tings, and peer authentication settings for PPP inter faces on your Motorola Netopia® Gate-
way.
Configuring Basic PPP Settings.
☛
NOTE:
For the DSL platform you must identify the vir tual PPP inter face [
vccn], a num-
ber from 1 to 8.
set ppp module [vccn] option { on | off }
Enables or disables PPP on the Motorola Netopia® Gateway.
set ppp module [vccn] auto-connect { on | off }
Suppor ts manual mode required for some vendors. The default
on is not normally
changed. If auto-connect is disabled (
off), you must manually start/stop a ppp connection.
set ppp module [vccn] mru
integer
Specifies the Maximum Receive Unit (MRU) for the PPP inter face. The integer argument
can be any number between 128 and 1492 for PPPoE; 1500 other wise.
can be any number between 128 and 1492 for PPPoE; 1500 other wise.
set ppp module [vccn] magic-number { on | off }
Enables or disables LCP magic number negotiation.