Справочник Пользователя для Hitachi wh9dm

15

Check the work area to make sure that it is clear of debris and clutter.
Clear the area of unnecessary personnel. Ensure that lighting and ventilation is adequate.

1. Using the convenient hook

The convenient hook can be installed on the right
or left side and the angle can be adjusted in 5 steps
between 0 and 80.

(1) Operating the hook

(a) Pull out the hook toward you in the direction of

arrow (A) and turn in the direction of arrow (B).
(Fig. 5)

(b) The angle can be adjusted in 5 steps (0°, 20°, 40°,

60°, 80°).
Adjust the angle of the hook to the desired
position for use.

(2) Switching the hook position

● If the tool falls, there is a risk that malfunction and/

● Incomplete installation of the hook may result in

bodily injury when used.
(a) Securely hold the main unit and remove the

screw using a slotted head screwdriver or a
coin. (Fig. 6)

(b) Remove the hook and spring. (Fig. 7)
(c) Install the hook and spring on the other side

and securely fasten with screw. (Fig. 6)

Pay attention to the spring orientation. Install

the spring with larger diameter away from you.
(Fig. 8)

(3) Using the bit holder
䡬 Installing the bit

Slide the bit from the side in the direction of Fig. 9,
and then insert firmly until the groove on the pit
locks in the protruded section of the hook.

䡬 Removing the bit

Securely hold the main unit and pull out the bit by
holding the tip with your thumb. (Fig. 10)

Fig. 6

Fig. 5

Fig. 8

Fig. 7

Convenient hook

Spring

Larger diameter
faces away