Справочник Пользователя для Dukane 403-575-00
Navigate to the Process Settings tab. All welder setup
related control parameters are programmed on this tab.
The Process Settings page is organized into 8 boxes:
The Process Settings page is organized into 8 boxes:
1 - Welder Type
2 - Initiate Mode
3 - Trigger
4 - Weld
5 - Post Weld
6 - Pressure
7 - Amplitude
8 - Secondary Control
These boxes organize the weld process into the events
that occur during the weld process.
Figure 4-26 shows the Welder Type selection.
Figure 4-26 shows the Welder Type selection.
Figure 4-26
iQ Explorer, Process Settings>Welder Type
Select
Press
.
Pneumatic Step 4 - Process Settings>Initiate Mode> Manual
NOTE
This Initiate Mode selection as-
sumes there is a stand-alone,
benchtop system with manual acti-
vation switches.
Figure 4-27
iQ Explorer, Process Settings>Initiate Mode> Manual
Select
Manual
.
Pneumatic Step 3 - Process Settings
Page 57
Dukane Manual Part No. 403-575-00
Section 4 - Operation
Lab
Lab
Dukane iQ Explorer - [Welder 1- Setup 4]
Dukane iQ Explorer - [Welder 1- Setup 4]