Справочник Пользователя для Integra dps-6.5

 

19

 

• The DPS-6.5 has two S Video output connectors. They 

output the same video signal.

• Line up the small triangle above the jack with the same 

mark on the plug before plugging in

 

You can use the component video output instead of the 
standard video out jack to connect this player to your TV 
(or other equipment).
This should give you the best quality picture from the 
three types of video output available.
• Use a component video cable (not supplied) to con-

nect the COMPONENT VIDEO OUTPUT jacks to a 
component video input on your TV, monitor or AV 
receiver.

• If your TV or projector has BNC component video 

inputs, use a BNC component video cable to connect 
them to the DPS-6.5’s BNC component video outputs.

• The DPS-6.5 has two component video outputs. The 

COMPONENT 1 output uses RCA connectors. The 
COMPONENT 2 output uses BNC connectors. They 
output the same video signal.

 

• Watching progressive scan video from the component 

video outputs 
This player can output progressive scan video from the 
component video output. Compared to interlace video, 
progressive scan video effectively doubles the scan-
ning rate of the picture, resulting in a very stable, 
flicker-free image. To set up the player for use with a 
progressive scan TV, see Video Output settings on 
page 43. When the player is set to output progressive 
scan video, the Progressive indicator lights in the front 
panel display.

 

• If you connect a TV that is not compatible with a pro-

gressive scan signal and switch the player to progres-
sive, you will not be able to see any picture at all. In 
this case, switch everything off and reconnect using 
the supplied video cable, then switch back to Interlace 
(see page 19).

 

Switch the player to standby then, using the front panel 
controls, press Standby/On while pressing 

 to switch 

the player back to Interlace.

 

This player is compatible with progressive video Macro 
Vision System Copy Guard.
Consumers should note that not all high-definition tele-
vision sets are fully compatible with this product and 
may cause artifacts to be displayed in the picture. In case 
of 525 progressive scan picture problems, it is recom-
mended that the user switch the connection to the “stan-
dard definition” output (Interlace). If there are questions 
regarding our TV set compatibility with this model, 
please contact our customer service center.

TV

　

TV

Open /Close

Standby/On

Standby

Display

Dimmer

DPS-6.5.book Page 19 Thursday, August 5, 2004 3:27 PM