Справочник Пользователя для InSinkErator ise hot water
Equipment You May Need:
We are delighted that you have chosen the InSinkErator
®
Instant Hot Water Dispenser to be a part of your home. This unique
appliance will save you time and effort in the kitchen, and you’ll enjoy
discovering new uses for it each day. That’s exactly why millions of people
are now using an InSinkErator Instant Hot Water Dispenser.
appliance will save you time and effort in the kitchen, and you’ll enjoy
discovering new uses for it each day. That’s exactly why millions of people
are now using an InSinkErator Instant Hot Water Dispenser.
We are confident that by following our step-by-step instructions, you’ll
soon be enjoying the convenience of instant hot water.
soon be enjoying the convenience of instant hot water.
n
n
For your satisfaction and safety, read all instructions, cautions, warnings and dangers before installing
or using this instant hot water dispenser.
or using this instant hot water dispenser.
n
n
This particular unit is not intended for commercial use.
n
n
Make sure that all electrical wiring and connections conform to local codes.
n
n
A standard 120-volt grounded electrical outlet is required under the sink for the dispenser’s electrical power.
n
n
The wall outlet powering your dispenser must have power supplied to it continuously.
n
n
This outlet must be fused and should not be controlled by the same wall switch that operates the
disposer, unless you have a SinkTop Switch
disposer, unless you have a SinkTop Switch
™
from InSinkErator
®
.
n
n
If you suspect elevated levels of chlorine in your water, it is recommended to use our water
filtration system.
filtration system.
n
n
The use of a water filter should NOT result in the water pressure to drop below 30 psi (207kPa).
If it does, this will prevent your unit from operating properly.
If it does, this will prevent your unit from operating properly.
n
n
Moving parts inside the tank causing a rattling noise is normal.
WHAT YOU SHOULD KNOW BEFORE YOU BEGIN
Equipment Required:
n
Drill
n
Compression fitting,
T-fitting or saddle valve
T-fitting or saddle valve
n
Adjustable wrench
n
Phillips and flat blade screwdrivers
n
Pencil
n
Tape Measure
n
Level
n
n
Anchors for drywall
n
n
Hole saw
n
n
Basin wrench
n
n
Hole punch
®
If you intend to use the sprayer hole in your sink for your dispenser, you may need a basin wrench and a
1/8" plug or a 1/4" cap (not supplied) for the faucet spray hose line. See Step 1-B.
1/8" plug or a 1/4" cap (not supplied) for the faucet spray hose line. See Step 1-B.
If you need to cut a mounting hole in your stainless steel sink, you may need a 1
1
⁄
4
" - 1
1
⁄
2
" hole saw made
for cutting stainless steel or a hole punch. Consult a professional if you are drilling into a surface other
than stainless steel.
than stainless steel.
WHAT YOU NEED TO GET STARTED
2