Справочник Пользователя для Metra Electronics 99-7400

Disconnect the negative battery terminal to 
prevent an accidental short circuit.  Remove 
(4) Phillips screws above the radio opening.  
Remove (1) Phillips screw below the left side of 
the radio opening.  Remove (1) Phillips screw 
from each side of the dash trim bezel.  Pull off 
the climate control knobs and remove the 
climate control trim panel.  Remove the 
ashtray and lift the dash trim bezel off.  
Remove (4) Phillips screws securing the 
factory head unit and disconnect the wiring.

NISSAN 200SX  1980-83

Using the scored lines as a guide, cut and 
remove the dashed portions of Faceplate 
#2.

Slide Mounting Tabs #5 into slots "A" on Brackets #13 and #14.  
The Mounting Tabs, Brackets and Bracket slots can be identified 
by the stamped letter on each component.   Skip to the Installation 
Instructions for ALL VEHICLES on Page #14.

2-SHAFT HEAD UNITS:  Snap the Faceplate onto the front of the Radio Housing.   Slide the 
aftermarket head unit into the kit and secure with shaft nuts.  (see Fig. A)

DIN HEAD UNITS:  Cut and remove the shaft supports from the Faceplate and Radio 
Housing.  Snap the Faceplate onto the front of the Housing.   Slide the DIN cage into the kit and 
secure by bending the metal locking tabs down.  Slide the aftermarket head unit into the cage 
until secure.   (see Fig. B)    

MAXIMA 1987-91, PULSAR 1987-90, STANZA 1987-89, 240SX:  Mount Bracket Set #9 to 
Radio Housing #1 with (4) Phillips Pan-head Screws supplied.   (see Fig. A)

SENTRA 1987-90:  Mount Bracket Set #12 to Radio Housing #2 with (2) Phillips Pan-head 
Screws supplied.   (see Fig. B).

STANZA 1982-86, 200SX, HARDBODY PICKUP, PATHFINDER:  Mount Bracket #13 and 
#14 to Radio Housing #2 with (4) Phillips Pan-head Screws supplied.  (see Fig. C)

MAXIMA 1982-84:  Mount Bracket #14 to Radio Housing #2 with (2) Phillips Pan-head 
Screws supplied.  (see Fig. D)

ALL VEHICLES