Справочник Пользователя для Metra Electronics 99-7400

Using the scored lines as a guide, cut and 
r e m o v e   t h e   d a s h e d   p o r t i o n s   o f            
Faceplate #2.

Disconnect the negative battery terminal to 
prevent an accidental short circuit.  Remove 
the knobs from the climate controls.  Using a 
small screwdriver, pry out on the climate 
control trim panel and remove.  Remove (2) 
screws securing the factory dummy plate 
and discard the plate. 

NISSAN Maxima  1982-84

Slide Mounting Tabs #8 into slots "C"  on Bracket Set #14.   The 
Mounting Tabs, Bracket and Bracket slots can be identified by the 
stamped letter on each component.  Skip to the Installation 
Instructions for ALL VEHICLES on Page #14.

Using the scored lines as a guide, cut 
and remove the dashed portions of 
Faceplate #2.   (This model does NOT 
require the use of a Radio Housing or 
Mounting Brackets).

Disconnect the negative battery terminal to 
prevent an accidental short circuit.  Remove (2) 
Phillips screws from the top of the dash trim 
bezel.  Remove the ashtray and (1) screw 
exposed on the ashtray bracket.  Remove the 
bracket.  Unclip the dash trim bezel and 
disconnect the wiring.  Remove (2) Phillips 
screws securing the factory head unit to the shelf.  
Remove the unit and disconnect the wiring.

NISSAN Pulsar  1983-86 / Sentra  1982-86

2-SHAFT HEAD UNITS:  Slide the aftermarket head unit into the dash trim bezel, place the 
Faceplate and Shaft Masks over the radio shafts and secure with shaft nuts.  (see Fig. A).  
Make wiring connections and re-attach the dash trim bezel. 

DIN HEAD UNITS:  Cut and remove the shaft supports from the Faceplate.   Cut a DIN opening 
in the dash trim bezel.  Slide the DIN cage through the Faceplate into the dash trim bezel and 
secure by bending the metal locking tabs down.  Make wiring connections and slide the 
aftermarket head unit into the cage until secure.  (see Fig. B).   Re-attach the dash trim bezel.