Справочник Пользователя для Mitsubishi diamond pro 87txm

12

On the back of the monitor are four  plug-in connections:  one for the AC power cord, DB9-
15P and BNC Connector for video and a DIN8P connector for the optional serial interface kit.

One end of the AC power cord is connected into the AC power connector on the back of the
monitor.  The other end is plugged into a properly grounded three-prong AC outlet.  The
monitor’s auto-sensing power supply can automatically detect 100-120V AC or 200-240V AC
and 50 or 60Hz.

The attached video signal cable provides a DB9-15P connector for the VGA compatible
analog RGB outputs on your computer.  The RGB signal may be derived from an IBM

®

 PS/2,

or compatible, Apple Macintosh built-in video or most third party color cards can be interfaced
using the AD-A205 adapter.

DB9-15P and BNC receptacle cannot be used simultaneously (at the same time).  If you
will use DB9-15P, do not connect any of the BNC receptacles.

Figure 3 shows the SC-B102 cable connection to the Video Graphics Array (VGA) port in an
IBM Personal System/2

®

 

Model 50, 60, 70 and 80, or any VGA compatible system.

1.

Power off, both the monitor and the computer.

2..

Connect the computer end of the SC-B102 cable to the 15-pin connector on the VGA
controller card.

3..

Connect the monitor end of the SC-B102 cable to the DB9-15P receptacle on the back
of the monitor.

4..

Power on the computer, then the monitor.

5.

After using the system, power off the monitor, then the computer.

The socket-outlet shall be location near the equipment and shall be easily accessible.
During servicing, disconnect the plug from the socket-outlet.

Méme si le moniteur est mis hors tension il reste toujours alimenté.  La prise secteur
devrait ainsi ètre facilement accssible en cas d'urgence.

Figure 3.

Power Cord

Computer

VGA

Compatible

System

CABLE SC-B102

R

G

B

VD

Serial

HD/COMP

Signal

DB9-15P

DB9-
15P