Справочник Пользователя для Homelite 17991f
NOTE
Vacuum tubes lock together securely. If tubes must be separated
for realignment, storage, etc., use the following procedure:
a) Remove tubes from inlet housing.
b) Apply a small amount of a soapy household cleaner to the tube
for realignment, storage, etc., use the following procedure:
a) Remove tubes from inlet housing.
b) Apply a small amount of a soapy household cleaner to the tube
connection for lubrication.
c) Hold ends of tubes and turn to unlock and separate.
Remove cleaner completely from tube ends before reassembly.
5. Loosen (do not remove) the inlet cover locking screw enough to allow
cover to unlatch and swing open.
6. Hold inlet cover open. Align locking tabs on inner tube with slots in inlet
housing. Push vacuum tubes into inlet housing and turn to lock.
4. Stand inner tube upright on floor as illustrated. Align angled end of outer
tube and decal on inner tube as shown. Push outer tube down into inner
tube to lock together.
tube to lock together.
CONTENTS
WARNING - FIRE HAZARD
--
For all blower/vacuum units the blower tube
MUST
MUST
MUST
MUST
MUST
remain attached to blower housing when the bag is attached.
DO
DO
DO
DO
DO
NOT
NOT
NOT
NOT
NOT
attach vacuum bag directly to blower housing!
VACUUM KIT
PART NO. 17991-F
Rev. 1
BLOWER
TUBE
TUBE
NO.
DESCRIPTION
QTY.
1.
TUBE- Inner
1
2.
TUBE- Outer
1
3.
STRAP- Shoulder
1
4.
HANDLE- Lower
1
5.
SCREW- Pan hd. #8 x 1/2"
2
6.
GROUND LEAD
1
7.
TERMINAL TAB, Male
1
8.
VACUUM BAG
1
INSTALLATION
INSTALLATION
INSTALLATION
INSTALLATION
INSTALLATION
1. Insert lower handle and align screw holes in blower housing as shown.
Place ground lead under indicated screw head. Install four screws and
tighten securely.
tighten securely.
2. If terminal tab was not factory installed, remove the existing crankcase
cover screw using a TX-25 Torx bit, and install the male terminal tab
as shown. Tighten screw securely.
as shown. Tighten screw securely.
3. Attach ground lead to terminal tab.
Wear eye and hearing protection
when operating this equipment.
when operating this equipment.
Read all Safety, Operating and
Maintenance Instructions
Maintenance Instructions
.
Indicates Warning,
Danger, and Caution.
Danger, and Caution.
SCREW
BLOWER
HOUSING
HOUSING
SCREW
GROUND
LEAD
LEAD
INSTALL
TERMINAL TAB
UNDER EXISTING
SCREW
TERMINAL TAB
UNDER EXISTING
SCREW
LOWER HANDLE
1
2
5
8
4
3
7
6
PUSH INTO
HOUSING
HOUSING
TURN TO LOCK
LOCKING SCREW
INLET COVER
ANGLED
END
END
PUSH DOWN
TO LOCK
TO LOCK
INNER
TUBE
TUBE
OUTER
TUBE
TUBE
DECAL