Справочник Пользователя для Garmin g1000 beechcraftbaron58 g58 pilots guide
190-00629-00 Rev. B
Garmin G1000 Pilot’s Guide for Beechcraft 58/G58
2-22
PRIMARY FLIGHT DISPLAY
NAVIGATION STATUS BAR
The Navigation Status Bar is located at the top of the
PFD and displays valuable information while flying a
route:
route:
• The next waypoint in the active flight plan
• Distance to the next waypoint (DIS)
• Desired track to the next waypoint (DTK)
• Current track angle (TRK)
• GPS Navigation Annunciations
• Distance to the next waypoint (DIS)
• Desired track to the next waypoint (DTK)
• Current track angle (TRK)
• GPS Navigation Annunciations
NOTE: The fields in the PFD Navigation Status
Bar cannot be changed.
Bar cannot be changed.
Figure 2-37 Navigation Status Bar Information Examples
Next Waypoint
Distance to
Next Waypoint
Desired Track
To
Next Waypoint
Current Track
Figure 2-38 Navigation Status Bar Messages
TRANSPONDER (XPDR) STATUS BAR
NOTE: Refer to the Transponder section for
information regarding transponder operation.
information regarding transponder operation.
The Transponder (XPDR) Status Bar is located in the
lower right corner and displays the transponder code,
reply symbol, and mode of operation.
reply symbol, and mode of operation.
Figure 2-39 Transponder Status Bar
Transponder code selection is performed with eight
softkeys (0-7) providing 4,096 active identification codes.
Pressing one of these softkeys begins the code selection
sequence. The new code is activated five seconds after
the fourth digit is entered. The BKSP softkey removes
one digit at a time until the status bar is empty. The
VFR softkey can be used to enter the pre-programmed
VFR code (1200 in the USA only) selected in G1000
configuration mode.
Pressing one of these softkeys begins the code selection
sequence. The new code is activated five seconds after
the fourth digit is entered. The BKSP softkey removes
one digit at a time until the status bar is empty. The
VFR softkey can be used to enter the pre-programmed
VFR code (1200 in the USA only) selected in G1000
configuration mode.
NOTE: Refer to ICAO standards for VFR codes in
other countries.
other countries.
Pressing the IDENT softkey activates the Special
Position Identification (SPI) pulse for 18 seconds,
identifying the transponder return on the ATC screen.
identifying the transponder return on the ATC screen.