Справочник Пользователя для Garmin gpsmap 495

Getting Started > 

Charging the GPSMAP 495

Before using the unit, you need to charge the battery in the 

GPSMAP 495. Plug the unit into a 12-Volt connector to charge. You 

can use the unit while it is charging. 

1.  Lift the rubber weather cap to expose the power connector on 

location.

2.  Align the notches, and push the plug into the connector until fully 

seated. 

3.  Plug the vehicle power cable into a vehicle power outlet 

(cigarette lighter receptacle) if you have a vehicle power cable. 

Use care when routing the power cable; be certain that it does 

not interfere with vehicle operation.

The unit begins charging as soon as external power is applied. 

Placing the unit in Charge Mode charges the unit more quickly than 

when the unit is turned on and reduces draw on the aircraft/vehicle/

boat battery.

Applying external power to the GPSMAP 495 automatically turns 

on the unit for full operation. If the battery is present and needs to be 

charged, the external power source charges the battery while the unit 

is in use. 

If you do not want to use the unit, but you would like to charge the 

battery, you can put the unit into Charge Mode. Connect the unit to 

an external power supply. Press and hold the POWER key. Instead 

of completely turning off, the unit now goes into Charge Mode, as 

shown below.

  NOTE: While in Charge Mode, the unit draws a small amount 

of current from the aircraft/vehicle/boat battery. To avoid 

discharging the vehicle’s battery, disconnect the external power 

cable from the GPSMAP 495 when not in use for several days. 

After using the unit a lot, you may notice that the lithium-ion battery 

in the unit is not holding a charge any more. This is common for 

lithium-ion batteries. Contact Garmin or your Garmin dealer to order 

a battery pack replacement if you are experiencing charging issues 

with your battery.