Справочник Пользователя для OKI fax 5050

The Federal Communications Commission Telephone Consumer
Protection Act of 1991 makes it unlawful for any person to use a
computer or other electronic device to send any message via a
telephone fax machine unless such message clearly contains in a
margin at the top or bottom of each transmitted page or on the first
page of the transmission, the date and time it is sent and an
identification of the business or other entity, or other individual
sending the message, and the telephone number of the sending
machine or such business, other entity, or individual.

To comply with this law, you must enter the following
information in your fax unit:

■

Date and time: see page 19 for instructions on doing this.

■

Name and telephone number which identify the source of
your fax transmission: see page 21 for instructions on doing
this.

The Industry Canada label identifies certified equipment.
This certification means that the equipment meets certain
telecommunications network protective, operational and safety
requirements. The Department does not guarantee the equipment
will operate to the user’s satisfaction.

Before installing this equipment, users should ensure that it is
permissible to be connected to the facilities of the local
telecommunications company. The equipment must also be installed
using an acceptable method of connection. In some cases, the

company’s inside wiring associated with a single line
individual service may be extended by means of a certified
connector assembly (telephone extension cord). The
customer should be aware that compliance with the above
conditions may not prevent degradation of service in some
situations.

Repairs to certified equipment should be made by an
authorized Canadian maintenance facility designated by the
supplier. Any repairs or alterations made by the user to this
equipment, or equipment malfunctions, may give the
telecommunications company cause to request the user to
disconnect the equipment.

Users should ensure for their own protection that the
electrical ground connections of the power utility, telephone
lines and internal metallic water pipe system, if present, are
connected together. This precaution may be particularly
important in rural areas.

■

Users should not attempt to make such connections them-
selves, but should contact the appropriate electric inspection
authority, or electrician, as appropriate.

The Load Number assigned to each terminal device denotes
the percentage of the total load to be connected to a
telephone loop which is used by the device, to prevent

OF5050M.PM6

4/15/98, 9:23 AM

4