Справочник Пользователя для Metra Electronics 95-5817
95-5817 KIT/FINAL ASSEMBLY
2
DOUBLE DIN/STACKED ISO MOUNT
UNIT(S) PROVISION
Attach the double DIN brackets to
the double DIN or stacked ISO Mount
unit(s) using the screws supplied
with the unit(s). (Figure A)
the double DIN or stacked ISO Mount
unit(s) using the screws supplied
with the unit(s). (Figure A)
1
*
Note: Refer also to the instructions included with the aftermarket radio.
A
B
NOTE: Sub dash modifications are necessary to use this dash kit. You will need to
trim the sub dash to gain suitable depth and height.
trim the sub dash to gain suitable depth and height.
A
B
C
D
(A) Strip wire ends back 1/2"
B) Twist ends together
C) Solder
D) Tape
Locate the factory wiring harness in
the dash. Metra recommends using
the proper mating adapter and mak-
ing the connections as shown.
(Isolate and individually tape off the
ends of any unused wires to prevent
electrical short circuit). (Figure B)
the dash. Metra recommends using
the proper mating adapter and mak-
ing the connections as shown.
(Isolate and individually tape off the
ends of any unused wires to prevent
electrical short circuit). (Figure B)
Re-connect the negative battery terminal
and test the unit for proper operation.
and test the unit for proper operation.
2
3
Continued on page 3.
NOTE: Once the kit is snapped in, it cannot be removed without dash panel removal.