Справочник Пользователя для Invacare careguard cg9701

Скачать
Страница из 4
1
Assembly, Installation and Operating Instructions
NOTE: The above model number contains one (1) Alter-
nating Pressure Pump and one (1) pad.
NOTE: Check ALL parts for shipping damage. In case of
shipping damage, DO NOT use. Contact Carrier/Dealer
for further instruction.
SAFETY SUMMARY
The following recommendations are made for the safe
use of the CareGuard APP Alternating Pressure Pump
and Pad:
WARNING
DO NOT use this equipment without first reading
and understanding this instruction sheet. If you
are unable to understand the Warnings, Cautions,
and  Instructions, contact your Invacare dealer
or Invacare Account Services  at 1-800-333-6900
before attempting to use this equipment - other-
wise, injury or damage may occur.
DO NOT use the pad near open flame or while
smoking, otherwise, injury may result.
Inspect power cord, plug, or air hoses of the
CareGuard APP Alternating Pressure Pump for
breaks, tears, or kinks. If damage is found, DO
NOT use.
DO NOT, under any circumstances, cut or remove
the round grounding prong from any plug used
with or for Invacare products. Some devices are
equipped with three-prong (grounding) plugs for
protection against possible shock hazards. Where
a two-prong wall receptacle is encountered, it is
the personal responsibility and obligation of the
customer to contact a qualified electrician and
have the two-prong receptacle replaced with
a properly grounded three-prong wall recep-
tacle in accordance with the National Electrical
Code. If you must use an extension cord, use
ONLY a three-wire extension cord having the
same or higher electrical rating as the device
being connected.
Ensure that  the pad  is  brought up to room tem-
perature before unfolding.
DO NOT place hot objects such as heating pads
on top of the pad. This may weaken the pad
material and may cause injury.
2. Place pad on top of bed mattress.
NOTE:  Air chamber openings should be at bed end.
3.     Install end flaps over mattress corners to secure pad.
CAREGUARD APP
ALTERNATING PRESSURE PUMP
MODEL NO. CG9701
WARNING
1.  Perform one (1) of the following:
A. Place the CareGuard APP Alternating Pres-
sure Pump on a flat surface near the bed.
B.   Open the hooks on the back of the CareGuard
APP Alternating Pressure Pump and install on
the outside of the bed frame as shown in FIG-
URE 1.
Pump
Hooks
(2 Each)
Outside
Bedframe
FIGURE 1- INSTALLING THE CAREGUARD APP -
ATTACHING PUMP  TO  BED
Rubber Feet
(4 each)
Hose Attachment
INSTALLING THE CAREGUARD
APP (FIGURES 1 AND 2)
Use extreme care when handling sharp objects
such as needles near the pad.
The  pad has a  weight limitation of  250 lbs. (114
kg.).
NOTE: Read the WARNINGS in the SAFETY SUM-
MARY before installation.