Справочник Пользователя для Metra Electronics 99-7477

Disconnect the negative battery terminal to prevent an accidental short circuit.  Remove the 
ashtray and (1) screw exposed in the top-right corner of the ashtray cavity.  Remove (2) Phillips 
screws above the climate controls.  Remove (2) Phillips screws from the base of the radio trim 
bezel.  Unclip the radio trim bezel and disconnect the cigarette lighter wiring.   Remove the 
bezel.  Remove (4) screws securing the factory head unit and disconnect the wiring.

Re-connect the battery terminal and test the unit for proper operation.  Mount the head uni t/kit 
assembly to the sub-dash with (4) screws previously removed in step #1.

Locate the factory wiring harness in the 
dash.  Metra recommends using the 
proper mating adaptor and making 
connections as shown.  (Isolate and 
individually tape off the ends of any 
unused wires to prevent electrical short 
circuit).

Locate the (4) mounting positions in the sub-dash 
("A").

ALL VEHICLES

2-SHAFT HEAD UNITS:  Slide the aftermarket head unit into the kit and secure with shaft 
nuts.  (see Fig. A)

DIN HEAD UNITS:   Cut and remove the shaft supports from the Radio Housing.  Slide the 
DIN cage into the kit and secure by bending the metal locking tabs down.  Slide the aftermarket 
head unit into the cage until secure.   (see Fig. B)