Справочник Пользователя для ICOM ic-a24

28

8

Cloning allows you to quickly and easily transfer the
programmed data from one transceiver to another
transceiver, or, data from PC to a transceiver using the
optional CS-A24 cloning software.

D Transceiver to transceiver cloning

q Connect the OPC-474 

CLONING CABLE

with adapter plugs

to [SP/MIC] jack of the master and slave transceivers.

• The master transceiver is used to send data to the slave trans-

ceiver.

w While push and holding [MR•

MW

],

push [PWR] to enter cloning mode
(for operating the master transceiver
only).

• “CLONE” appears and the transceivers

enter the clone standby condition.

e Push [MR•

MW

] on the master trans-

ceiver.

• “CL-OUT” appears in the master trans-

ceiver’s display.

• “COURSE DEVIATION NEEDLES”

shows that cloning is taking place

• “CL-IN” appears automatically in the

slave transceiver’s display.

r When cloning is finished, turn power OFF, then ON again

to exit cloning mode.

NOTE: DO NOT transfer the data from IC-A24 to IC-A6,
when the data contains the NAV band data. In such case,
cloning error may occur.

DCloning using PC

Data can be cloned to and from a PC (Microsoft

®

, Windows

®

98/98SE/Me/2000/XP) using the optional CS-A24 

CLONING

SOFTWARE

and the optional OPC-478 (RS-232C type) or

OPC-478U (USB type) 

CLONING CABLE

. Consult the CS-A24

CLONING SOFTWARE

HELP file for details.

D Cloning error

NOTE: DO NOT push [ENT•

WX

] on the slave transceiver

during cloning. This will cause a cloning error.

When the display at right appears, a
cloning error has occurred.

In this case, both transceivers automatically return to the
clone standby condition and cloning must be repeated.

Microsoft and Windows are registered trademarks of Mi-
crosoft Corporation in the U.S.A. and other countries.

“COURSE DEVIATION
NEEDLES” shows that
cloning is taking place.