Справочник Пользователя для ONKYO dv-sp502e

23

Connecting the DV-SP502/DV-SP502E—Continued

If your AV receiver has 5.1 channel analog inputs, we 
recommend connecting this player to it using the multi-
channel analog outputs. Doing this will ensure that you 
can enjoy all kinds of disc, including Dolby Digital and 
DTS DVD-Video discs, as well as high sampling rate 
and multichannel DVD-Audio and SACD discs.

SUBWOOFER outputs on this player to the 
multi-channel audio inputs on your AV receiver.
It’s convenient to use three stereo audio cables; one 
for the FRONT/D.MIX 1 or 2, one for the SURR and 
one for the CENTER and SUBWOOFER channels.

You can use the SCART AV connector, or the S 
video or component video jacks to connect to the AV 
receiver if you prefer.

Tip:
• After connecting up and switching on, you should 

change the Audio Output Mode setting in the Initial 
Setup menu from the default 2 Channel to 5.1 Chan-
nel. See also Audio Output Mode on page 48, 52.

• The remote controller supplied with Onkyo AV 

receiver or amplifiers can be used to control the DV-
SP502/DV-SP502E.

• The function of the upper and lower 

 connectors are 

the same. Connect to either one.

• Connecting an 

 cable only does not make the sys-

tem operational. You must also connect the audio 
cables as well.

• For remote control operation, you must make an ana-

log RCA connection between your DV-SP502/DV-
SP502E and the other AV component, even if they are 
connected digitally.

AV receiver

Signal flow

AV receiver