Справочник Пользователя для Q-See QS206
PART 3 - CONNECTING THE DVR TO YOUR DISPLAY
PART 4 - DVR CONTROLS: FRONT PANEL
1 2
3
4
5
VGA
USB
AUDIO IN
CVBS OUT
AUDIO
OUT
VIDEO IN
1
GND
COM1
NO1
COM2
NO2
GND
485A-2
485B-2
GND
485A-1
485B-1
GND
+12V
GND
2
3
4
5
6
7
8
9
10
11
12
13
14
16
15
ALM IN
RJ45
DC +12V
IN
1
2
3
4
NOTE! To switch back and forth between VGA and TV, use the
Mouse Scroll-Wheel: Forward-switch to VGA
Mouse Scroll-Wheel: Forward-switch to VGA
Backward-switch to CVBS (TV).
IMPORTANT!
The default resolution of this DVR is 1024x768 pixels. Some
monitors smaller than 19” may have problems displaying this resolution.
Item #
Name/ Symbol
Description
1
STANDBY
Press to set the system in standby mode.
2
MENU/EXIT
Press to open/close the main menu.
3
CHANNEL/
NUMBERS/
PLAYBACK
NUMBERS/
PLAYBACK
Press the number buttons to select a channel and view it full-
screen; press buttons 1-0 to input passwords and user IDs.
screen; press buttons 1-0 to input passwords and user IDs.
4
NAVIGATION/
OK
OK
OK
In menus, press to confirm selections; in PTZ mode,
press to change the navigation buttons to control a
connected PTZ camera (not included)
press to change the navigation buttons to control a
connected PTZ camera (not included)
▲
Press to move cursor up; in PTZ mode, press to pan
camera up.
camera up.
▼
Press to move cursor down; in PTZ mode, press to
pan camera down.
pan camera down.
◄
Press to move cursor left; in PTZ mode, press to pan
camera left.
camera left.
►
Press to move cursor right; in PTZ mode, press to
pan camera right.
pan camera right.
5
LED
INDICATORS
INDICATORS
Shows status of hard drive, recording, alarm, HDD full and
network.
network.
6
DURING
PLAYBACK
PRESS:
PLAYBACK
PRESS:
◄ ◄
Increase reverse playback speed 1X, 2X, 4X.
n
/
►
Press to freeze playback to one frame, then press
again to advance frame-by-frame.
again to advance frame-by-frame.
►
Press to start playback
► ►
|
Press to slow playback speed by 1/2, 1/4, 1/8.
► ►
Press to increase forward playback speed 1X, 2X,
4X.
4X.
7
IR SENSOR
IR Receiver for remote control.
8
USB
Connect a USB flash drive for data backup and
firmware upgrades
firmware upgrades
To Connect to a Computer Monitor:
To Connect to a TV:
1. Plug the VGA cable (not included) to the VGA port on the DVR.
2. Connect the other end of the VGA cable to the monitor.
2. Connect the other end of the VGA cable to the monitor.
3. Plug the BNC to RCA adapter cable into the Video Out port on the DVR.
4. Connect the other end of the RCA cable to the Video Input on the TV.
4. Connect the other end of the RCA cable to the Video Input on the TV.