Справочник Пользователя для Human Touch ijoy-250
Human Touch Confidential
Page 1
Human Touch
iJoy-250 Replacing the Power Panel
Initiator: MG
Replaces:
NA
Revision date: 101006
Title:
Replacement of the iJoy 170/173 Side Power Panel Remote and
AC Cord Assembly
Purpose: To provide end users with the procedure for replacement of the iJoy-170/173 Side Panel – this
replaces the Remote with cord, AC Cord and On/Off Switch.
replaces the Remote with cord, AC Cord and On/Off Switch.
Tools/Parts Required: Phillips Screwdriver, diagonal cutters (optional)
Requires Side Panel Unit with ON/OFF power switch/ AC cord
Procedure:
1)
Turn off and unplug your iJoy
2)
As an option, you can carefully tip your unit onto its Right Side (the side opposite the
AC cord). This will make it easier to access the assembly and side cover.
AC cord). This will make it easier to access the assembly and side cover.
3)
Locate The Side Panel Assembly. This is the plate that both the AC cord and
remote cord enter. This assembly also incorporates the ON/OFF switch.
remote cord enter. This assembly also incorporates the ON/OFF switch.
4)
You will need to either remove the SN/Model information label from the Side Panel
Assembly, or locate the two screw holes covered by the label. You can find the hole
by feeling the sticker for a depression. Using the Phillips Screwdriver, gently poke a
hole to access the screw. See photo for screw location. Please note this sticker
contains critical product information, including model and serial number.
Assembly, or locate the two screw holes covered by the label. You can find the hole
by feeling the sticker for a depression. Using the Phillips Screwdriver, gently poke a
hole to access the screw. See photo for screw location. Please note this sticker
contains critical product information, including model and serial number.
5)
Remove two (2) screws securing the Side Panel Assembly to the chair frame.
6)
Carefully Remove the Side Panel Assembly. Caution: The Side Panel Assembly
remains connected via cables to the chair. Note: You may need to carefully cut
cable-ties if they prevent you from removing the connectors in the following steps.
remains connected via cables to the chair. Note: You may need to carefully cut
cable-ties if they prevent you from removing the connectors in the following steps.
7)
Locate the white 11-pin plug attaching the Remote Control to the Chair. Carefully
disconnect. Disconnect the remaining plugs attaching the panel assembly to the
chair.
disconnect. Disconnect the remaining plugs attaching the panel assembly to the
chair.
8)
Reconnect All Connector Plugs to New Side Panel Assembly
9)
Install New Side Panel, ensuring material is smoothed out in recess.
10)
Reinsert the two (2) screws removed in step 5.
11)
Plug the iJoy back into the wall outlet, and turn the Main Power Switch on.
12)
Test the chair for proper operation.