Справочник Пользователя для rosen-entertainment-syste ds-ty0820

Installation Guide Toyota Corolla

Rosen Entertainment Systems

Installation Guide

DP-TY0824 Rev A

Page 4

7 – Connect and Install the Rosen Unit

You will need to make the Electrical Connections and install the Rosen Unit. The following steps will help guide you
through this process.

Note: Connect BRAKE WIRE (blue w/ white) to Emergency brake switch wire (ground when E-brake is
engaged). This insures video is disabled while vehicle is in motion.

Note: Use caution when locating the wire harnesses to be sure they will not be damaged when the Rosen unit is
installed.

Note: For vehicles with Dual Diversity Antenna, connect the White Antenna lead only, and protect the second
antenna lead from damage. For improved Radio performance, use an aftermarket dual diversity antenna adaptor.

Step 1: Remove transport

screws

Step 2: Connect the GPS,

Steering Wheel Control
and Power Connections

Step 3: Connect the iPod and

optional XM, Camera and
Backing Sensors

Step 4: Prepare the Vehicle side

connection harnesses

8 – Re-Install Interior Trim Components

You will need to re-install the interior trim components. The following steps will help guide you through this process.

Note: When Installing the Interior Trim Components, use caution to prevent damage to the components. If you are
unsure about the removal process, consult the OEM Service Manual for additional instructions.

Step 1: Attach the Electrical

Connection and install the
Vent Trim

Step 2: Install the Lower Trim

Components

Step 3: Install the Upper Trim

Component

Step 4: Verify unit operation

Use Caution. See the OEM Service Manual for additional information on the installation process

Insure that the video disable connection is connected as intended and working as designed!!!

Be sure to fully engage all connectors and prevent them from causing vibrating noises