Справочник Пользователя для Kenwood sovereign vr-5900

Chapter Two : Setting Up PowerTouch

7. Carefully listen to the volume level of the test noise. If

the noise is a different volume than the noise from the

front left speaker, use 

 or 

 to adjust the vol-

ume so that the volume matches the volume from the
front left speaker. (Do not be concerned with the vol-
ume number readout on the Level display—this is for
reference purposes only. Use your ears to determine if
the two speakers are playing at the same volume).

8. Repeat steps 6 and 7 until all the system’s speakers (except

the subwoofer) play at the same volume.

9. To confirm the volume levels, touch 

 until the Test

Tone display reads “Auto”. The test noise will automati-
cally cycle between all of the speakers. Fine-tune the chan-
nel levels as necessary.

10. When all the channels sound like they’re the same vol-

ume, you’ve balanced your system.

11. To turn off the test noise, touch 

 until the Test Tone

display reads “Off”.

Setting the Subwoofer Level: Because of the way hu-
mans hear, the test noise the Speaker Level menu sends
through the subwoofer will not sound as loud as it re-
ally is. (The Speaker Level menu subwoofer test noise is
designed to be used with a sound pressure level meter
for balancing.)

Because of this, you cannot use that test noise to prop-
erly calibrate the level of your subwoofer by ear. To set
the subwoofer level, listen to familiar music or films
that have strong bass content and adjust the subwoofer
level until it sounds balanced with the rest of the speak-
ers.

13. Touch 

 to move to the next speaker setting or touch

 to return to the Setup Surround menu.

In this step you will use your ears to balance the volume level
of all the system’s speakers except the subwoofer for your room
and listening position. (To set the subwoofer level, see “Set-
ting the Subwoofer Level” on this page.) When all the speak-
ers are set at the same volume level, your system will create a
more realistic, spacious surround sound environment.

1. Eliminate as many external noise sources as possible.

2. Sit in the place where you and your guests are most likely

to sit while watching movies or listening to music.

3. If you are not already there, touch 

 on the

Setup Surround menu to open the Speaker Level menu:

4. Touch 

 until the Test Tone display reads “Manu”.

5. Test noise will play from the front left speaker. Care-

fully listen to the volume level of the noise.

6. Touch 

 or 

 to select the next speaker.

In this step, you set the maximum volume of the bass sound
so that the speaker sounds are not distorted even when
excessively-large bass signal is input. When playback is
performed hereafter, the bass sound is regulated automatically
so as not to exceed the level set here.

1. Touch 

 on the Setup Surround setting menu.

Or touch 

 on the Speaker Level menu.

2. Touch 

 on the Bass Peak Level setting menu.

The test tone is output. (displayed “-30 dB”)

The level of the test tone is not affected by the current
setting of the volume control.

3. Touch the 

 or 

 to adjust the speaker level at

a level just before the audio starts to be distorted.

4. Touch the 

 to complete the setting.

5. Touch the 

 to return to the Setup Surround menu.

Do not output the test tone for a long period while the
speaker audio is distorted.