Справочник Пользователя для Crestron cen-oem

Crestron eServer™  

Ethernet 

OEM 

Module

Use the “cancel” command to terminate an operating system upgrade that is in 
progress. This command can be used at any time (e.g., after a "prepare" comand or 
while a transfer file is in progress.  

Entering the “version” command provides the firmware version currently running 
within the connected eServer.  

The "password" command permits the user to set a password for accessing the 
eServer via TCP/IP. Enter the password after the "password" command and a blank 
space. For example: 

password hello 

Entering the “options” command without any arguments displays the available 
system options and respective settings. For example, observe the following response 
to the “options” command.  

 

A Saved and Current column is displayed. Saved is the setting after power up. 
Current defines the true setting as detected by the system. For example, notice in the 
previous illustration that SIMPL+ is Saved: ON and Current: OFF. This indicates 
that even though SIMPL+ has been enabled after power up, it is impossible to 
support this setting because SIMPL+ is not running. Enter the appropriate "options" 
command to change the Saved setting. A reboot is required to take effect.  

A brief description of valid settings is shown below.  

SIMPL+ – permits SIMPL+ program to execute 
PRINT FROM SIMPL+ – for debugging purposes; permits printing to console 

from SIMPL+ 

PASSTHRU – permits serial port passthru 
KILL_CIP_ON_ACTIVE_PASSTHRU – disables CIP program during passthru 
DEBUG – for use with a Crestron technical representative only 
SYS_MESSAGES – suppresses all unprompted messages 
TELNET CONSOLE – permits access through Telnet (port 23) 

•  19