Справочник Пользователя для Crestron pac2

Professional Automation Computer 

 

Crestron PAC2

The on-board 36MB memory of the 2-Series integrated dual bus control system is 
enhanced with a 4GB expansion slot that supports off-the-shelf Type II compact 
flash memory and the IBM Microdrive



 hard drive. The slot is accessible on the 

front panel of the unit. Complete the procedures in the following subsections to 
install and remove the memory cards. Power does not have to be disconnected to 
insert or remove memory. Note that compact flash memory supports FAT32 file 
structure.  

1.  Loosen the screw that secures the memory slot cover located to the left 

of the COMPUTER port on the rear panel.  

2.  Pull on the screw to remove the screw and cover.  

3.  Observe handling precautions of the memory card manufacturer and 

insert into the open slot.  

4.  Align and reposition cover over slot.  

5.  Tighten the screw.  

1.  Loosen the screw that secures the memory slot cover located to the left 

of the COMPUTER port on the rear panel.  

2.  Pull on the screw to remove the screw and cover.  

3.  Press the eject button located on the extreme right of the slot.  

4.  Observe handling precautions of the memory card manufacturer and 

remove card from the slot.  

5.  Align and reposition cover over slot.  

6.  Tighten the screw.  

As of the date of manufacture, this unit has been tested and found to comply with 
specifications for CE marking and standards per EMC and Radiocommunications 
Compliance Labelling.  

          

 

NOTE:  This device complies with part 15 of the FCC rules. Operation is subject to 
the following two conditions: (1) this device may not cause harmful interference, and 
(2) this device must accept any interference received, including interference that may 
cause undesired operation.  

•  Professional Automation Computer: PAC2